How to Add Automatic Lighting to a Closet
Lighting expert Scott Caron shows a homeowner how to brighten up a dark closet and never have to flip on a light switch
In this video, lighting expert Scott Caron shows a homeowner how to brighten up a dark closet and never have to flip on a light switch.
1. Find an existing power source near the location of your closets and shut off the power.
2. Cut the current power source line with wire cutters.
3. Add in an electrical junction box.
4. Splice new 14-guage wires to the old connection using pliers and wire connecting nuts.
5. Locate space between the studs in the ceiling and drill a hole using the power drill. This will be the location for the switch.
6. Place two pieces of 14-gauge wire down the hole to the closet location behind the drywall—one to power the switch and one to power the fixture.
7. Drill a second hole in the ceiling where you want your light fixture to go.
8. Feed one of the 14-gauge wires through the hole and make the electrical connections to the light fixture using pliers and wire nuts.
9. Cut out a square hole in the closet drywall using a jab saw.
10. Feed both sets of wires through the plastic old-work electrical box, then install the box in the hole by tightening the screws in the box to secure it to the drywall.
11. Splice the wires together with pliers and wire nuts and add in a spare piece of wire to serve as a connection to the switch. Connect the motion-activated light switch to these wires using a screwdriver.
12. If using a ball switch instead of a motion-activated switch, only one power wire can be fed from the power source. A transformer is connected to the light fixture to convert 120 volts to low voltage, then low-voltage wires are fed from the transformer to the ball switch.
13. To install the ball switch in the doorjamb, drill out a hole in the frame of the closet door using a power drill and a spade bit. Insert the ball switch and low voltage wiring through the framing. You'll likely have to take off the trim and nail it back on.