How to Roll Paint Onto a Wall
The right way to load a roller and use it without leaving streaks and bumps
In this video, learn the right way to load a roller and use it without leaving streaks and bumps.
TIP 1: Remove lint from a new roller cover with painter's tape or a vacuum, and roll it into the paint tray until it's half coated. Roll the cover up onto the grooves, then back into the paint. Do this a couple of times until the entire cover is saturated but not overloaded; that way, it won't spatter or cause drips.
TIP 2: Roll the wall in a W or N pattern to coat the surface in wide sections. Work along a wet edge that's been cut in, and get as close to the trim as possible to avoid leaving a ribbon of brush marks around the edges of the wall.
TIP 3: Use moderate pressure on the roller. Too much pressure causes a bead, or “rope,” along the edge, while too little pressure can make your arm tired. At the end of each stroke, lightly lift the roller away from the wall to avoid creating a distinct edge.
See the rest of the Beyond the Basics: Painting series:
• 1. How to Pick a Paint
• 2. How to Choose a Primer
• 3. How to Pick a Paintbrush
• 4. How to Choose a Roller
• 5. How to Prep the Room
• 6. How to Prep the Walls
• 7. How to Use a Brush
• 8. How to Roll Paint Onto a Wall
• 9. How to Clean a Brush
• 10. How to Clean a Roller