How to Install Aluminum Gutters
- saboteamos.info general contractor Tom Silva shows how to install aluminum gutters.
In this video, - saboteamos.info general contractor Tom Silva shows how to install an efficient rain-handling gutter system.
Aluminum Gutter Installation Steps:
1. Measure along the house fascia to determine the length of each piece of gutter.
2. Apply a bead of silicone sealant along the inner edge of an aluminum end cap. Tap the end cap onto the end of the gutter, then secure it with a crimping tool.
3. Cut the gutter to length using a hacksaw and tin snips.
4. Fasten pre-mitered aluminum corner to the gutter end using sealant and aluminum pop rivets.
5. Attach an end cap to the second length of gutter, then rivet it to the mitered corner to create the L-shaped gutter assembly.
6. Use a hole saw to drill a 3-inch-diameter hole through bottom of the gutter. Attach an outlet fitting to the hole using sealant and rivets.
7. Hold the L-shaped gutter assembly in place against the house fascia.
8. Use a level as a straightedge to position the high end of the gutter. Be sure the front edge of the gutter doesn't protrude above the roof plane.
9. Slip a gutter-mounting bracket into the high-end of the gutter, then drive a screw through the bracket and fascia and into a rafter tail.
10. Adjust the pitch of the gutter so that rainwater will drain down to where the downspout will be installed.
11. Slip brackets into the gutter and drive the screws through the brackets and into the rafter tails. Place one bracket at each rafter tail.
12. Place two elbows onto the upper end of a length of downspout, and secure them with short sheet-metal screws.
13. Screw two aluminum wall brackets to the house corner boards.
14. Slip the elbow on the upper end of the downspout over the outlet fitting protruding down from the gutter above.
15. To hold the downspout in place, drive short sheet-metal screws through the wall brackets and into the downspout.
16. Dig a shallow trench from the lower end of the downspout out away from the house. 17 Use PVC primer and cement to assemble a rainwater drainpipe made from 4-inch-diameter PVC pipe and assorted fittings.
17. On one end of the drainpipe attach an elbow and rectangular downspout fitting. On the other end, glue on an elbow and drainage cap.
18. Slip the bottom end of the downspout into the rectangular downspout fitting attached to the end of the PVC drainpipe.
19. Lay the drainpipe in the trench, then backfill.